DESCRIPTION
When powered on, the current mode will flash to indicate mode before going into operation. Press the STOP key to switch between ON and OFF. This functions as an emergency stop, which disconnects the relay when OFF.
Setup Mode:
- Press and hold the SET key for 2 seconds, then select mode with UP and DOWN keys.
- After selecting the mode, short-press the SET key to set the corresponding parameters. At this time, the parameters to be set will flash (OP = open time, CL = close time, LOP = cycle number ("---" represents infinite cycles)), and adjust the parameter values with UP and DOWN keys.
- After setting the values, short-press the STOP key to select the decimal point position and the timing range (0.1s - 999min)
- After setting the parameters of the selected mode, press and hold the SET button for 2 seconds to exit setup mode. The current set mode will flash before going into operation.
Operation Mode:
- P1: After the trigger signal, the relay is turned on OP time, and then disconnected; in the OP time, as follows:
- P1.1: Nothing happens when the signal is triggered again. Wait for the cycle to complete before triggering again.
- P1.2: Triggering again will restart the timer.
- P1.3: Triggering again will stop and restart the timer and turn off the relay.
- P-2: When triggered, the timer will start counting for CL time, then turn the relay on for OP time. After the time is completed, the relay is disconnected.
- P3.1: When triggered, the relay turns on for OP time, then disconnects for CL time, and then the cycle repeats for the number of set LOP.
- P3.2: After power-on, the Delay Off Module is triggered automatically and the relay turns on for OP time, then disconnects for CL time, and then the cycle repeats for the number of set LOP.
- P-4: When the input signal is present, the relay turns on and timing remains at 0 until the input signal is removed. When the input signal is removed, the relay then waits for OP time before it disconnects; Any time the signal is triggered again the timer starts from 0.
Sleep Mode:
- Press and hold the STOP key for 2 seconds to switch between C-L and O-d.
- C-L: Within five minutes if there is no operation, the display automatically turns off while the module continues to runs normally.
- O-d: Display always stays on.
TECHNICAL DETAILS
- Operating Voltage: 6V - 30V
- Trigger: HIGH trigger (3V - 24V)
- Operating Current: 50mA
- Timing Range: 0.1s - 999min
- Working Temperature: -40°C to 85°C
SHIPPING LIST
- 1x Delay Off Module
>