Cultivate Curiosity, Inspire Imagination.
The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you solder SJ2 closed on the EasyDriver). EasyDriver requires a 6 - 30V supply to power the motor and can power any voltage of stepper motor. The EasyDriver has an on board voltage regulator for the digital interface that can be set to 5V or 3.3V. Connect a 4-wire stepper motor and a microcontroller and you've got precision motor control! EasyDriver drives bi-polar motors, and motors wired as bi-polar. I.E. 4,6, or 8 wire stepper motors.
It provides much more flexibility and control over your stepper motor, when compared to older versions. The microstep select (MS1 and MS2) pins of the A3967 are broken out allowing adjustments to the microstepping resolution. The sleep and enable pins are also broken out for further control.
NOTE: DO NOT CONNECT OR DISCONNECT A MOTOR WHILE THE DRIVER IS ENERGIZED. THIS WILL CAUSE PERMANENT DAMAGE TO THE A3967 IC.
- Input Voltage: 6 - 30V
- Drive Current: 150mA / phase to 700mA / phase
- Microstep Resolution: Full, Half, Quarter and Eighth Steps
- 1x Stepper Motor Driver EasyDriver A3967
- 1x Male Pin Headers